Using X431 To Set Toyota Corolla Pressure Monitor Transmitter Registration

[forumoto]

REGISTRATION

 

 

 

DESCRIPTION OF CODE REGISTRATION

It is necessary to register the transmitter IDs in the tire pressure warning ECU when replacing a tire pressure warning valve and transmitter and/or tire pressure warning ECU.

Prepare all transmitter ID data before starting registration.

 

 

(a) Before registration

(1) When replacing the tire pressure warning ECU:

 

Read the registered transmitter IDs that are stored in the old ECU using Techstream and note them down.

If reading stored transmitter IDs is impossible due to malfunctions of components such as the tire pressure warning antenna and receiver, remove the tires from the wheels and check the IDs located on the tire pressure warning valve and transmitters (See: Service Precautions).

(2) When replacing a tire pressure warning valve and transmitter:

 

Take note of the 7-digit number (transmitter ID) written on the tire pressure warning valve and transmitter.

 

 

 

 

 

 

NOTE: The transmitter ID is written on the tire pressure warning valve and transmitter. It will be unable to be read after installing the tire onto the wheel. Therefore, take note of the transmitter ID before installing the tire onto the wheel.

 

 

 

REGISTER TRANSMITTER ID (USING TECHSTREAM)

(a) Set the air pressure of all tires to the specified value (See: Service Precautions).

(b) Turn the ignition switch to the LOCK position.

© Connect Techstream to the DLC3.

(d) Turn the ignition switch to the ON position and turn the tester on.

(e) Enter the menu items in this order: Chassis / Tire Pressure Monitor / Utility / ID Registration.

(f) Perform the following procedures displayed on the screen.

(g) Confirmation of transmitter ID registration.

(1) Enter the menu items in this order: Chassis / Tire Pressure Monitor / Data List.

(2) Read the "ID Tire Inflation Pressure" values.

(3) Confirm that the data of tire pressure of all tires are displayed on the screen.

 

NOTICE:

 

 

It takes about 2 or 3 minutes to display the updated tire pressure data. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24 (See: Powertrain Management\Computers and Control Systems\Testing and Inspection\Diagnostic Trouble Code Tests and Associated Procedures\Manufacturer Code Charts\DTC 21\Tire Pressure Monitoring).

If the IDs have not been registered, DTC C2171/71 is set in the tire pressure warning ECU after 3 minutes or more.

If normal pressure values are displayed, the IDs have been registered correctly.

If the tire pressure values are not displayed after several minutes, the IDs may be incorrect or the system may have a malfunction.

(h) Confirm that the tire pressure warning light is off.

 

NOTE: After all IDs are registered, DTC C2126/26 (Transmitter ID not Received in Main Mode) is set in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then comes on. When the tire pressure warning ECU successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is deleted and the tire pressure warning light goes off.

[stepcio]

Hi you wrote x431 but I see it's Techstream

maybe someone know how to do that by diagun ?

[ivansilver]

Same way..... Just enter the HEX addresses you pull from sensors. It should work.